![]() Please call TELUS Technical Support at 1-85 to resolve the issue and complete your installation. If you are testing your sensor using the TELUS SmartHome mobile app and the device is consistently failing to pass the walk test, it is possible that you entered an incorrect sensor ID at an earlier stage or that the sensor is malfunctioning. One 100ms chirp at end of power-up sequence Green, yellow and red flash sequence every 12 seconds One 100ms chirp every 45 seconds (press button to hush for 12 hours) StatusĪNSI S3.41 temporal 4 (press button to hush for 5 minutes) If your CO Detector is flashing or making a sound, see below for more information about the LED lights on your device and what the pattern may indicate. My CO Detector is flashing/ making a sound Fit the detector inside the base by aligning it over the base as shown (detector’s alignment notch should be slightly offset from mounting base tamper release tab), then turn the detector in a clockwise direction until it clicks into place.Maneuver the base so the screws are at the elbow of the screw slots and secure. Refer to the diagram below and install the mounting base on the ceiling or on the wall (if local ordinances permit) using screw locations as required. Here is how the First Alert carbon monoxide detector acts when you press test/silence button or it detects carbon monoxide at alarm level.Anywhere the sensor can be knocked, damaged or inadvertently removed.In a location where dirt or dust could collect and block the sensor.In a location where the air flow is obstructed by curtains or furniture.Within five feet of any cooking appliances.Directly above a sink, cooker, stove or oven.Inside any room that contains a fuel burning appliance (or just outside any room with a fuel burning appliance if the room is not used regularly).At least 6" from the ceiling but not lower than a light switch if wall mounted.Exposure to high moisture and humidity may also affect the functionality of your device. Your CO detector should be placed at an adequate distance of 15 to 20 feet away so it does not pick up a false reading. At least 12" from any wall if ceiling mounted Placing your CO detector too close to these appliances may expose it to increased levels of carbon monoxide and trigger the alarm.Make sure you wipe the location before installing your sensor. Your CO Detector should be installed on a clean surface area inside your home.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |